Breakout board for 8-pin ATtiny microcontrollers

Since I didn’t had one, I decided to build a simple breakout and ISP board for 8-pin ATtiny microcontrollers, like the ATtiny13 or ATtiny85.

For each pin I added a female and male header. Additional pin headers are for VCC and GND.

Perfboard layout created with DIYLC.
Mounted on a piece of wood. The ISP header is on the right side. Reset button and LED are for debugging .
For each of the 8 pins there is a male and female header. The 3-pin headers on the left side are GND and VCC, respectively.
The Mini-USB port is only for powering the board, the USB data lines aren’t connected, since there is no serial RX/TX chip.

1 Reply to “Breakout board for 8-pin ATtiny microcontrollers”

Leave a Reply

Your email address will not be published. Required fields are marked *